6-K

FORM 6-K

SECURITIES AND EXCHANGE COMMISSION

Washington, D.C. 20549

REPORT OF FOREIGN PRIVATE ISSUER

Pursuant to Rule 13a-16 or 15d-16

of the Securities Exchange Act of 1934

For the month of June 2015

Commission File Number 000- 13355

ASM INTERNATIONAL N.V.

(Translation of registrant’s name into English)

VERSTERKERSTRAAT 8

1322 AP ALMERE

THE NETHERLANDS

(Address of principal executive offices)

Indicate by check mark whether the registrant files or will file annual reports under cover of Form 20-F or Form 40-F.

Form 20-F  ý    Form 40-F  ¨

Indicate by check mark if the registrant is submitting the form 6-K in paper as permitted by Regulation S-T Rule 101(b)(l):  ¨

Note: Regulation S-T Rule 101(b)(1) only permits the submission in paper of a Form 6-K if submitted solely to provide an attached annual report to security holders.

Indicate by check mark if the registrant is submitting the Form 6-K in paper as permitted by Regulation S-T Rule l0l(b)(7):  ¨

Note: Regulation S-T Rule l0l(b)(7) only permits the submission in paper of a Form 6-K if submitted to furnish a report or other document that the registrant foreign private issuer must furnish and make public under the laws of the jurisdiction in which the registrant is incorporated, domiciled or legally organized (the registrant’s “home country”), or under the rules of the home country exchange on which the registrant’s securities are traded, as long as the report or other document is not a press release, is not required to be and had not been distributed to the registrant’s security holders, and, if discussing a material event, has already been the subject of a Form 6-K submission or other Commission filing on EDGAR.

Indicate by check mark whether the registrant by furnishing the information contained in this Form is also thereby furnishing the information to the Commission pursuant to Rule l2g3-2(b) under the Securities Exchange Act of 1934.    Yes  ¨    No  ý

If “Yes” is marked, indicate below the file number assigned to the registrant in connection with Rule 12g3-2(b): 82-.

Exhibits
Exhibit 99.1	ASM INTERNATIONAL N.V. TO HOST TECHNOLOGY SEMINAR

SIGNATURES

Pursuant to the requirements of the Securities Exchange Act of 1934, the registrant has duly caused this report to be signed on its behalf by the undersigned hereunto duly authorized.

Dated: June 29, 2015	ASM INTERNATIONAL N.V.
		/S/    HANS ZWEERS
		Hans Zweers
		Director External Reporting and Treasury

ASM INTERNATIONAL N.V.

(THE “REGISTRANT”)

(COMMISSION FILE NO. 0-13355)

EXHIBIT INDEX

TO

FORM 6-K

DATED June 29, 2015

Exhibit No.	Exhibit Description	Filed Herewith
99.1	ASM INTERNATIONAL N.V. TO HOST TECHNOLOGY SEMINAR		X

EX-99.1

Almere, The Netherlands

June 26, 2015

ASM INTERNATIONAL N.V. TO HOST TECHNOLOGY SEMINAR

ASM International N.V. (NASDAQ: ASMI and Euronext Amsterdam: ASM) today announces that it will be hosting a technical seminar in Portland, OR, US, on Tuesday June 30, 2015,the second day of the ALD Conference.
In this ‘All about ALD’ technology seminar, ASM and a distinguished guest speaker will address challenges and opportunities for ALD processes and equipment to manufacture next generations of micro-electronic devices.

The agenda is as follows:

5.30     pm     Reception, drinks and food
6.15-6.30 pm     Dr. ir. Ivo Raaijmakers (ASM) - Welcome and introduction
6.30-7.00 pm     Dr. Jeffrey Elam (Argonne National Laboratory) - "Selective ALD in polymers: sequential         infiltration synthesis for lithography and nanofabrication "
7.00-7.20 pm     Dr. Suvi Haukka (ASM) - " Present and future challenges of atomic layer deposition "

Following the presentations, there is room for open discussion and networking until 9.00 pm.

The ASM technology seminar will take place in the Skyline room I-II at the Portland Hilton, 921 SW Sixth Ave., Portland, OR, 97204 US. The room will open at 5:30 pm for invited attendees. Interested parties should contact Rosanne de Vries, +31 88 100 8569,rosanne.de.vries@asm.com.

1 of 3

About ASM International

ASM International NV, headquartered in Almere, the Netherlands, its subsidiaries and participations design and manufacture equipment and materials used to produce semiconductor devices. ASM International, its subsidiaries and participations provide production solutions for wafer processing (Front-end segment) as well as for assembly & packaging and surface mount technology (Back-end segment) through facilities in the United States, Europe, Japan and Asia. ASM International's common stock trades on NASDAQ (symbol ASMI) and the Euronext Amsterdam Stock Exchange (symbol ASM). For more information, visit ASMI's website at www.asm.com.

Safe Harbor Statement under the U.S. Private Securities Litigation Reform Act of 1995: All matters discussed in this statement, except for any historical data, are forward-looking statements. Forward-looking statements involve risks and uncertainties that could cause actual results to differ materially from those in the forward-looking statements. These include, but are not limited to, economic conditions and trends in the semiconductor industry generally and the timing of the industry cycles specifically, currency fluctuations, corporate transactions, financing and liquidity matters, the success of restructurings, the timing of significant orders, market acceptance of new products, competitive factors, litigation involving intellectual property, shareholder and other issues, commercial and economic disruption due to natural disasters, terrorist activity, armed conflict or political instability, epidemics and other risks indicated in the Company's filings from time to time with the U.S. Securities and Exchange Commission, including, but not limited to, the Company's reports on Form 20-F and Form 6-K. The Company assumes no obligation nor intends to update or revise any forward-looking statements to reflect future developments or circumstances.

CONTACT

Rosanne de Vries
T: +31 88 100 8569
M:+31 651 25 2448
E: rosanne.de.vries@asm.com

2 of 3